Transtape

A Spanish Hacking Device from HM (Hard Micro, S.A.).

Transtape

Technical

Uses a 16KB ROM paged into memory at &0000.
Uses a 8KB static RAM paged into memory at &c000-&dfff and repeats again at &e000-&ffff.
ROM is paged into the range &0000-&3fff when the red button is pressed and the NMI vector is executed.
When the black button is pressed, the ROM is paged into the range &0000-&3fff and executes it at &0000.
This checks the BASIC ROM version, and clears the extra ram if a BASIC ROM from a CPC6128 is found.

Code:

0000 f3        di                               ;; disable maskable interrupts
0001 0100df    ld      bc,0df00h		;; select upper rom 0
0004 ed49      out     (c),c
0006 01817f    ld      bc,7f81h			;; enable upper rom (mode 1 too)
0009 ed49      out     (c),c
000b 31febf    ld      sp,0bffeh                ;; setup stack which is not initialised after reset

000e 3a02c0    ld      a,(0c002h)               ;; read BASIC ROM version number
0011 fe02      cp      02h                      ;; CPC6128?
0013 cc2e0c    call    z,0c2eh		        ;; erase extra RAM

;; this appears to set it up for a reset..
0016 210000    ld      hl,0000h
0019 e5        push    hl			
001a e5        push    hl
001b c30038    jp      3800h                    ;; I think the hardware monitors for address 3800h and if found disables the ROM

Uses NMI
Doesn't capture the hardware state like the Multiface does. Code in the ROM reads the hardware state which it restores when resuming the program.
RAMDIS is asserted when ROM or RAM are active meaning no write through to ram behind.
Menu code is at offset &3810 and is copied into RAM at &A200.
Uses port FBF0 (write only)

FBF0 decoding is:
1111 1011 1111 00xx

FBF0 output:
bit 0 is ram enable/disable state
bit 1 is rom enable/disable state
bit 2 is A10 on RAM
bit 3 is A11 on RAM
bit 4 is A12 on RAM
bits 5-7 are not used.

Uses port FBFF (input).

bit 7 is used to report lower rom and upper rom enabled state.

Transtape ROM performs a read of 3ffe (lower rom) and fffe (upper rom) and records the state of ROMEN.

Decoding of FBFF is:

1111 1011 1111 11xx

The same plastic case is used by the Spectrum version of this interface.
The spectrum version has two switches on the top. One of which chooses load/save. In the Amstrad these holes are filled with plastic caps.