Fischertechnik Trainingsrobot
The Trainingsrobot is a robotic arm made by the German company Fischertechnik.
Note: Fischertechnik additionally made the Fischertechnik Computing Experimental robot kit for the CPC.
This trainingsrobot was also produced for other 8bit computers of the era. (Commodore 64/VIC20 and the BBC micro)
The only difference was the interface.
The interface for the CPC (as well as newer RS232/USB versions) consists of:
- 8 single bit inputs ports (eg. for sensing when a robot-arm reached its end-position)
- 4 "bidirectional" ports (for motor control) (here "bidirectional" rather means "three-state-output" aka "forward/stop/backward")
- 2 analog inputs (eg. for temperature sensor)
Technical
Fischertechnik has built several interfaces:
- C64/VIC20 probably required a custom interface (?)
- Interface for one-directional printer port (used on PCs) (this might have been also used by CPC ?)
- Interface for RS232 port (used on PCs) (9600 baud, 8bit, no parity, 1 stopbit)
- Interface for USB port (used on PCs)
Parallel Printer Port Interface
Designed for one-directional printer ports: Data is read via BUSY line (which data is to be read is selected via DATA lines) (details on how the data is transferred exactly are unknown?).
Printer Pin Interface Signal Comment Pin2 (Data Bit0) Load-out ;motor control output Pin3 (Data Bit1) Load-in ;digital sensor 8bit input Pin4 (Data Bit2) Data-out ;data from computer Pin5 (Data Bit3) Clock ;data clock Pin6 (Data Bit4) Trigger-x ;analog sensor X input Pin7 (Data Bit5) Trigger-y ;analog sensor Y input Pin11 (Busy) Data-in ;data to computer
Reviews
The trainingsrobot was reviewed in the danish magazine Amstradbladet 1986, Issue 3/4 (page 4-6)
Pictures
- Fischertechnik Trainingsrobot
Schneider box
The manual
Robot in closeup
Connected to CPC6128
Robot and interface
The Robot at an exibition in Spain
Weblinks
http://www.fischer.de/ fischer group homepage
