Difference between revisions of "Vortex Disc Drives"

Revision as of 14:14, 27 January 2018

Disc drives from Vortex, with 80 tracks and 720K capacity (704K available).

Vortex -S and -D Drives (720K/disk)

• F1 - S Single 5.25" drive with power supply connected via ribbon cable to interface with NEC765 andVDOS 1.0
• F1 - D Double 5.25" drive with power supply connected via ribbon cable to interface with NEC765 andVDOS 1.0
• M1 - S Single 3.5" drive with power supply connected via ribbon cable to interface with NEC765 andVDOS 1.0
• M1 - D Double 3.5" drive with power supply connected via ribbon cable to interface with NEC765 andVDOS 1.0

These are the original drives from Vortex, for use on CPC 464. The interface supports one or two 80 track drives, additionally a 3" FD-1 can be connected as third drive, ie. unlike most other CPC disk interfaces it supports more than 2 drives. With VDOS only two drives are accessible at one time.

TO BE CONFIRMED: Does the interface fully decode US0/US1 from NEC765 and if you select unit 3 which drive is accessed.

Vortex -Z Drives (180K/side or 180K/disk?)

• F1 - Z Single 5.25" drive without FDC, without VDOS
• M1 - Z Single 3.5" drive without FDC, without VDOS

These are the Low-Capacity drives from Vortex, for use on CPC 664/6128 or CPC 464 with DDI-1 (ie. on computers that already have a FDC and AMSDOS). There doesn't seem to be anything special about this product, just an off-the-shelf disk drive, shipped with a CPC-specific connection cable.

AMSDOS can only access 40 tracks. TO BE CONFIRMED: Are the drives 80 track, double sided? Is there any way to access the second side with AMSDOS (e.g. side switch??)

Vortex -X Drives (720K/disk)

• F1 - X Single 5.25" drive without FDC, with VDOS 2.0
• M1 - X Single 80 Track, Double Sided, 3.5" drive without FDC, with VDOS 2.0 (not inside drive)
• F1 - XRS same as F1-X, upgraded with RS232 interface
• M1 - XRS same as M1-X, upgraded with RS232 interface

These are the newest drives from Vortex, for use on CPC 664/6128 or CPC 464 with DDI-1 (ie. on computers that already have a FDC). The |S command (for accessing a third drive) is no longer used, the new |X command allows to swap drive A and B (same as X-DDOS from Dobbertin)

Vortex Add-ons

• Vortex X modul (adding RS232 support to -X drives)
• VDOS2.0 (upgrading older drives to VDOS 2.0)
• Second drive unit (for upgrading a single -S drive to a dual -D drive)

I/O Ports

 Standard Addresses (same as used by AMSDOS):
   FB7Eh 765 FDC (internal) Status Register (R)
   FB7Fh 765 FDC (internal) Data Register (R/W)
   FA7Eh Floppy Motor On/Off Flipflop
 Special Addresses (secondary FDC):
   FBF6h 765 FDC (Vortex,ext) Status Register (Read)
   FBF7h 765 FDC (Vortex,ext) Data Register (R/W)
   FA7Eh Floppy Motor On/Off Flipflop (same as normal)
 (The Special addresses are mentioned in the manual
 for the Vortex -X drives) (but apparently they are referring
 to other/older Vortex drives, not the -X drives)

The Special addresses are used only on CPC 664/6128 and only if the Vortex drive includes an FDC chip.

The X drive has a different PCB than the PCB for the S, the manual describes connecting the DDI-1 interface to the X drive interface and a 'decoder-ROM' which defines the I/O decoding?

• Note1: The -Z and -X drives do not include FDC chips.
• Note2: The -S and -D drives do reportedly work only on CPC 464 (?).

So, not sure if/when the Special addresses are used at all?

 RS232 Ports (for -X drives with RS232)
   FADC/FADD=Serial Data/Control
   FBDC/FBDD/FBDF=Counter 0/1/Mode.
 So it's probably compatible with Amstrad/Pace 
 (and probably also including, but not using,
 Channel B Ports FADE/FADF and FBDE).

Vortex Disk Format

See VDOS

The Vortex -Z drives do not seem to include any VDOS ROM (so they do support only normal 40-Track AMSDOS Formats, but NOT the 80-Track Vortex format).

Pictures

• The Vortex F1 Drives
• 

  F1-Z Disc Drive

• 

  F1-D Disc Drive

• Vortex Disc Drive Interface (for -S or -D drives)
• 

  A anonymous box houses the controller

• 

  Look inside the controller, with 765 chip, and VDOS (upgraded to v2.0)

• 

  Controller with VDOS mounted

• Vortex Disc Drive Interface (for -X drives)
• 

  Newer -X drive interface without 765

• 

  Newer -X drive interface without 765, plus RS232

• Vortex M1-X drive
• 

  Front of Vortex M1-X

• 

  Underneath the Vortex M1-X

• 

  Inside the Vortex M1-X showing the drive and power

• 

  Back of Vortex M1-X showing connectors and power.

• 

  Back of Vortex M1-X showing IDC connection

• 

  Inside Vortex M1-X with a close up of the drive from above

• 

  Inside Vortex M1-X with a close up of the back of the drive

Manuals

• Vortex Floppy Disk Station F1 (Manual for old drives with VDOS 1.0)
• Vortex X-Laufwerke (Manual for new X-drives with VDOS 2.0)
• Vortex VDOS 2.0 (Manual for upgrading from VDOS 1.0 to VDOS 2.0)
• Manual de las Unidades Vortex (pdf)
• Vortex RS232-C Manual (pdf)
• NEC drive inside Vortex M1-X NEC drive inside Vortex M1-X