Difference between revisions of "Test Circuit used for ACID reverse engineering"
From CPCWiki - THE Amstrad CPC encyclopedia!
(→Pictures) |
|||
| Line 3: | Line 3: | ||
== Schematic == | == Schematic == | ||
| − | Desoldered [[ASIC]] chip from Fano's cartridge (thanks, Fano), attached to PC's parallel printer port: | + | Desoldered [[ASIC]] chip from [[Fano]]'s cartridge (thanks, Fano), attached to PC's parallel printer port: |
ACID PC | ACID PC | ||
CLK ---- Strobe | CLK ---- Strobe | ||
Revision as of 10:43, 20 February 2010
ACID Reverse Engineering
Schematic
Desoldered ASIC chip from Fano's cartridge (thanks, Fano), attached to PC's parallel printer port:
ACID PC CLK ---- Strobe CCLR ---- Init SIN ---- Busy /OE ---- Select A0..A7 ---- Data 0..7 GND,5V ---- GND,5V
Pictures
- Original messy circuit
Top
Bottom
Parents desk
This is original circuit, assembled while I was visiting my parents. I couldn't find a 36pin centronics socket, only a (very) old 25pin RS232 cable, so I needed to use that.
- Newer clean circuit
Top
Bottom
Nocash Headquarters
When I came back home, I wrecked the original circuit, and made a miniaturized adapter with robust centronics socket. Not that I'd still really needed it - I've been already done with the rev engineering at that time - I just don't like messy cables.
