Difference between revisions of "Connector:Cassette recorder"
From CPCWiki - THE Amstrad CPC encyclopedia!
Line 11: | Line 11: | ||
== KC Compact Tape Connector == | == KC Compact Tape Connector == | ||
+ | [[KC Compact]] uses a 5pin DIN connector | ||
1 Cas-Write __ __ | 1 Cas-Write __ __ | ||
2 GND / - \ | 2 GND / - \ | ||
Line 18: | Line 19: | ||
Shield GND | Shield GND | ||
* Caution: The connector looks same as on CPC, but the Pin-Outs are entirely different, and, Motor On is a TTL output (instead of a Relais) | * Caution: The connector looks same as on CPC, but the Pin-Outs are entirely different, and, Motor On is a TTL output (instead of a Relais) | ||
+ | |||
+ | == Aleste Tape/Sound Connector (female) == | ||
+ | [[Aleste 520EX]] uses a 5pin female DIN connector | ||
+ | 1 Tape In __ __ | ||
+ | 2 GND / - \ | ||
+ | 3 Sound Mono-Left | | | ||
+ | 4 Tape Out |3 1| | ||
+ | 5 Sould Mono-Right \5_2_4/ | ||
+ | Shield GND | ||
+ | * The Left/Right pins are actually shortcut with each other on the Aleste mainboard, so sound is mono. | ||
+ | * There is no Tape Motor Control (the corresponding PIO bit is mis-used as Printer Strobe in the Aleste). |
Revision as of 05:19, 11 February 2010
CPC Tape Connector
External Cassette Connector (CPC 664/6128 only) (5 pin DIN, female)
1 Remote Control __ __ 2 Ground / - \ 3 Remote Control | | 4 Data Input |3 1| 5 Data Output \5_2_4/
- The two Remote Control pins are connected to a relais inside of the CPC, the relais becomes closed when the /Motor On bit in PIO Port C is set to zero, ie. the cassette recorder may use the relais to switch its power suppy on and off when Play and/or Record is pressed - this is of course supposed for low-voltages only.
- The CPC 6128+ does not include a Cassette Connector.
KC Compact Tape Connector
KC Compact uses a 5pin DIN connector
1 Cas-Write __ __ 2 GND / - \ 3 Cas-Read | | 4 Sound-Mono |3 1| 5 Motor On (TTL) \5_2_4/ Shield GND
- Caution: The connector looks same as on CPC, but the Pin-Outs are entirely different, and, Motor On is a TTL output (instead of a Relais)
Aleste Tape/Sound Connector (female)
Aleste 520EX uses a 5pin female DIN connector
1 Tape In __ __ 2 GND / - \ 3 Sound Mono-Left | | 4 Tape Out |3 1| 5 Sould Mono-Right \5_2_4/ Shield GND
- The Left/Right pins are actually shortcut with each other on the Aleste mainboard, so sound is mono.
- There is no Tape Motor Control (the corresponding PIO bit is mis-used as Printer Strobe in the Aleste).