Difference between revisions of "Joystick Y-cables"
(→Technical) |
(→Examples) |
||
| Line 22: | Line 22: | ||
<gallery> | <gallery> | ||
Image:Amstrad joysplit.jpg|Y-box with 5 diodes | Image:Amstrad joysplit.jpg|Y-box with 5 diodes | ||
| − | Image:Joy-Y.jpg | + | Image:Joy-Y.jpg|Joystick Y-cable |
Image:Joystick.jpg|Schematic with TOO MANY diodes | Image:Joystick.jpg|Schematic with TOO MANY diodes | ||
</gallery> | </gallery> | ||
[[Category:Hardware]] [[Category:Peripherals]] [[Category:DIY]] | [[Category:Hardware]] [[Category:Peripherals]] [[Category:DIY]] | ||
Revision as of 12:12, 25 January 2010
These were made by 3rd party vendors as a replacement to the original JY-2 joystick for the Amstrad CPC computers.
In order to push sales of Amstrad's own joysticks, Amstrad designed the CPC with one joystick port only which had two common signal pins. The idea was to sell one joystick which forwarded the second common signal to a built-in joystick port, to which the second joystick could be connected.
As the quality of the Amstrad joysticks was lousy, using an Y-cable together with other joysticks was the preferred solution.
Technical
Basically, Pin8 needs to be swapped with Pin9 for the second joystick. However, the cable should also contain diodes in order to prevent conflicts between the two joysticks.
For example, if Player 1 moves UP-and-RIGHT then UP and RIGHT are shortcut with each other. In result, without the diodes, Player 2 would automatically move UP-and-RIGHT whenever trying to move UP-or-RIGHT.
The diodes are, of course, needed only on one connector (eg. Joystick 2 only). The schematic with diodes on both Joystick 1 and 2 connectors is a bit overcomplicated.
See Also
Joystick Splitter (an article from an english magazine, describing how to make a Y-cable)
Examples
Y-box with 5 diodes
Joystick Y-cable
Schematic with TOO MANY diodes
