Difference between revisions of "Music Machine"
m (added subcategory) |
|||
| Line 105: | Line 105: | ||
</gallery> | </gallery> | ||
| − | [[Category:Hardware]] [[Category:Peripherals]] [[Category:Music and sound]] | + | [[Category:Hardware]] [[Category:Peripherals]] [[Category:Music and sound]][[Category:Manual]] |
Revision as of 10:38, 1 November 2006
A digital sound sampling and playback device. The Music Machine was built by a British Company called Ram Electronics.
The Amstrad CPC version was almost identical to the the ZX Spectrum version, only difference was the address decoding logic.
The Music Machine came with a simple microphone. Recording quality could be improved by using a better(and more expensive) microphone. It came with its own sound sampling software and a sequencer.
No known emulator supports the Music Machine. No other software than RAMs own sequencer is know to use the Music Machine.
The Music Machine was never used for producing sound effects in Demos.
Technical Specifications
Information from the manual:
The Music Machine incoporates two Ferranti devices for digital-to-analogue (DAC) and analogue-tod-digital (A to D) conversion. The part numbers are ZN429E8 and ZN449 respectively. The circuit also include a Motorola 6850 ACIA (Asynchronous Communications Interface Adapter) for handling the MIDI channel, two anti-alias filters (one for input and one for output), a discrete microphone amplifier and a headphone amplifier. The clock signal for the ACIA and the ZN449 is provided by a ceramic oscillator.
The incomming signalo from the microphone amplifier is sampled to an 8-bit resolution at a rate of 19.444 thoudsand samples per second. This yields an analogue bandwidth of approximately 9.5KHz which is in fact the cutoff frequency of the filters.
All of the devices on The Music Machine data bus are accessible to the Amstrad within its IO space. ACIA transactions must use 16-bit IO instructions; the converters are accesible via 8-bit IO instructions.
| I/O Map | Port | Meaning |
| ADC START | &F8F8 | Reading or writing to this port will start analogue to digital conversion |
| ADC READ | &F8F4(Read only) | The contents of the A-to-D can be read via this port. Note that the A-to-D must have been startet at least 20uS before this port can be read |
| DAC WRITE | &F8F0(Write only) | Data can written to the DAC via this port |
| INTERUPT SEL | &F8E8(Write only) | Writing 01 to this port disables internal Amstrad interrupts and replaces the IRQ signal from ACIA. Writing 00 restores normality. |
| ACIA Status | &F8EE(Read only) | Se Motorola datasheet |
| ACIA Data read | &F8EF(Read only) | Se Motorola datasheet |
| ACIA Control | &F8EC(Write only) | Se Motorola datasheet |
| ACIA Data write | &F8ED(Write only) | Se Motorola datasheet |
Weblinks
Spanish site about the Music Machine
Other similar devices
Digiblaster (Sampling/Playback)
Amdrum (Playback)
EMR MIDI Interface (Midi)
Pictures
- The Music Machine
Edge connector missing
Backside
PCB
PCB
The microphone
The microphone
Manual
- Ram Music Machine Manual
Frontpage
Contents
Page 1
Page 2-3
Page 4-5
Page 5-6
Page 8-9
Page 10-11
Page 12-13
Page 14-15
Page 16-17
Page 18-19
Page 20-21
Page 22-23
Page 24-25
Page 26-27
Page 28-29
Page 30-31
Page 32-33
Page 34-35
Page 36-37
