Changes
The [[ECB Bus]] connector of the board is intended to be plugged into the [[Schneiderware Basisplatine]], but it could be also wired directly to the CPCs Expansion Port.
----
Databoxes: '''UHR8000''' RTC-RAM-driver in 10-1986 (hex listing, plus [[Hisoft Devpac]] source code) (caution this version uses incorrect I/O addresses FBE1-FBE3), '''UHRC000X''' RTC-ROM-driver in 4-1987 (this version uses correct I/O addresses FBE2-FBE4). Uni-PIO examples in 12-1986 (=only a few basic lines). There seem to be no Centronics and V/24 drivers included in databoxes.
|Address (default) || Address (alternate) || Usage
|-
|DFxxh || N/A || Schneiderware RAM/EPROM - [[Upper ROM Bank Number|Expansion ROM bank number ]] (W)<br>Battery-backed SRAM and/or EPROM are selected when the bank-number matches the jumper-selected values; the memory is then mapped to C000h..FFFFh (in case of READing one must also enable upper ROM via Gate Array). The bank number decoding is a bit strange:
* EPROM/Read bank: All 8 bits decoded (bank 00h..FFh)
* SRAM/Read bank: Only lower 4 bits decoded (bank X0h..XFh)
