Changes
* a push button
'''WARNING: You are dealing with 0.005 kilovolts. You do this project at your own risk!'''
== Connections of the Reset Button ==
[[Image:Reset.gif]]
'''NOTE:'' * ' The GND and button can be connected to /RESET signals are available at (pin 41) or /BUS RESET (pin 40) on expansion port. Of which, BUS RESET is the Expansion connector correct pin (RESET would work too, but it wouldn't reset the PIO, and it would cause a harmless shortcut on a logic gate).
== Internal Reset Switch ==
* Dissassemble the computer
* Locate the BUS RESET track at the expansion port (pin 4140) The position of pin 1 is marked on the P.C.B.
* Solder one end of a piece of wire to the track, and the other end to one of the pins on the push button.
* Locate the GND track at the expansion port (pin 2). There are other GND connections on the circuit board that can also be used.
For the external reset button you will need a plug for the expansion connector. (a 50-way female edge connector for an English CPC).
* Locate the BUS RESET pin at the plug (pin 4140)
* Solder one end of a piece of wire to the pin, and the other end to one of the pins on the push button.
* Locate the GND pin at the plug (pin 2).
