Changes

*Sega Genesis (MegaDrivetoo?) It' used a slightly different approach in joystick connection than Atari. The Sega joystick pinout seems to be the "standard" 2-button joystick configuration where pins 6 and 9 are used for buttons which ground the pin when pressed. The only strange thing is that the joystick seems to also want +5V at pin 5. Sega has added a 6-button model in addition to its original 3-button configuration. The 6-button joysticks use essentially the same interface, but add more buttons by using extra circuitry that multiplexes the new button signals with the existing joystick signals, using the control bit in connector pin 7. The chip inside the controller is a 74HC157. This is a high-speed CMOS quad 2-line to 1-line multiplexer. The console can, with help of the Select pin, choose from two functions on each input.

''Each button (left, right, button 1 ect.) is in fact a voltage(very small), this voltage is grounded to result in movement, fire, jump ect. For standard master system controllers this is directly feed to the system via wires only (some other controllers use a micro chip) they also are not connected to voltage, while some others do.The Sega Genesis (in Europe sold as Sega MegaDrive) pads are an extension to the Sega Master System pads. They use more buttons (3+1, 5+1, 6+1). They use the one usnused pin as a select pin for reading more buttons.'' Those SMS standard controlers may be used alsmot unchanged on a CPC if the software allows to redefine controls. As a result you may use only one button : the fire 2 wich would be the button 1 on the controller. It seems the "Power" button on SMS controlers is used when the controler is fitted with AutoFire option (needs to be checked) or when using the Lightgun.

[[Category:Hardware]][[Category:Peripherals]][[Category:Stub]]