Changes

== Loading disc software using "<code>|CPM" </code> ==

You should attempt to start a program on a disc using this method if there is a "Read fail" “Read fail” error with the "<code>CAT" </code> or "<code>|DIR" </code> commands.

* # Restart the computer (follow the instructions above).* # At the "Ready" “Ready” prompt, type:<code>|CPM</code> and then press the large ENTER key (CPC464) or RETURN key (CPC6128, CPC464+,CPC6128+).

'''Note:''' The <code>|CPM</code> symbol can be obtained by pressing SHIFT and “@” (at) together on the Amstrad keyboard.

[Picture showing '|CPM' command] # The screen will clear. There are 3 possible results: 1.==== Read fail ====

If you press the "R" “R” key, then the "read fail" “read fail” message is repeated. If you press "I" or "C" keys then the following message is displayed.

[Picture showing 'Read fail' “Read fail” error after '<code>|CPM' </code> command has been executed]

These errors show that the command has failed and that the program can't be started using the "<code>|CPM" </code> command.

[Picture showing 'Failed “Failed to load boot sector' sector” error after '<code>|CPM' </code> command has been executed] This error shows that the command has failed and the program can't be started using the "|CPM" command. 3.

The program will load This error shows that the command has failed and run! The the program can 't be started using the "<code>|CPM" </code> command.