Comparing C64 to CPC

Comparing CPC and C64

• The C64 was released in 1982, the CPC released in 1984.

• The C64 was designed to be connected to a television (PAL: 50Hz, NTSC: 60Hz). The CPC was designed to be connected to a green screen or colour monitor.

• The C64 has a palette of 16 colours. The Amstrad has a palette of 27 colours.

• The C64 has a 1.0MHz 6510 CPU (a 6502 based CPU). The CPC has a 4.0Mhz Z80 CPU.

• The C64 has a programmable raster interrupt. You can define the line at which the interrupt will be triggered. The CPC has 6 "raster" interrupts at fixed positions through the 50Hz frame.

• The C64 has 50Hz and 60Hz variants (for regions where PAL and NTSC are used), the clocks inside the C64 are based off this. The CPC is 50Hz only.

• The C64's color RAM, SID, VIC and other hardware can be made visible within

the 6510's memory space. Access to them is done using normal read/write operations. All access to the CPC's hardware is done using the Z80's special I/O instructions.

• The C64 has pixel-by-pixel hardware scrolling in both the horizontal and vertical. The CPC has hardware scrolling. Using R5 of the CRTC and Rupture demo technique pixel-by-pixel scrolling in the vertical direction can be achieved. Using R3 of the CRTC 1 byte at a time in the horizontal is possible (which equates to 2 pixels in mode 0, 4 in mode 1, and 8 in mode 2).

• The C64 has the SID sound chip. The CPC has the AY-3-8912 sound chip.

• The C64 has the VIC video chip. The CPC has the 6845 CRTC and Gate-Array.

• The C64 tape loading is done through interrupts so is not intensive on the cpc. The CPC tape loading is intensive on the CPU.

- The C64 communicates with the disc drive through a wired serial connection. This means loading from disc is slow unless a special loader is used. The CPC's disc interface loads quick.

• The CPC can do overscan (rupture or 32K screen method), the C64 can do it, but only sprites can be displayed where the border was.

Comparison of the SID and AY-3-8912

AY sound chip has 3 tone channels, 1 noise channel and 1 hardware envelope. A mixer can be used to enable/disable tone output for each channel, The volume of each tone channel can be independantly controlled, OR be controlled by a hardware envelope.

Comparing Amstrad Plus and C64

• The C64 was released in 1982, the Plus released in 1990.

• The C64 has a palette of 16 colours. The Plus has a palette of 4096 colours.

• The C64 has a 1.0MHz 6510 CPU (a 6502 based CPU with I/O ports based at location &0000 and &0001). The Plus has a 4.0Mhz Z80 CPU.

• Both the C64 and Plus have pixel-by-pixel hardware scrolling both in the horizontal and vertical. (pixel by pixel scrolling requires Plus extra features)

• Both the C64 and Plus have programmable raster interrupts. e.g. you can set whichline of the display an interrupt can occur on.

(requires Plus extra features)

• The C64 has the VIC video chip. The Plus has the ASIC.

Sprite Comparisons

C64:

• The C64 has 8 hardware sprites.
• Each sprites can be one of two resolutions: high resolution or multicolour.
• You can define 1 unique colour for each sprite.
• The priority of sprite-to-sprite is fixed. Sprite 0 has a higher priority than sprite 8.

The pixel size in high resolution is comparable to CPC's mode 1. Each pixel can be either transparent OR a colour unique for each sprite. The pixel size in multicolour is comparable to CPC's mode 0.

• The Plus has 16 hardware sprites. They share a seperate 16 colour palette. They can have a resolution the same as mode 2 or magnified to have a resolution like mode 1 or mode 0. Each sprite is 16x16 pixels.

The Plus sprites can have more colours and are higher resolution compared to the C64's sprites.

(Plus extra features must be activated using a special control sequence. When this is done, the ASIC registers can be made visible in memory between &4000-&7fff. The Plus registers can then be accessed using normal memory read/write operations).