Difference between revisions of "Talk:Programming:Fast Sprites"
From CPCWiki - THE Amstrad CPC encyclopedia!
m (Removing all content from page) |
|||
| Line 1: | Line 1: | ||
| + | If you have enough memory, the fastest way to plot sprites is to use the "direct addressing" methode: | ||
| + | Here is a small example: | ||
| + | <pre> | ||
| + | LD HL,screen address | ||
| + | LD BC,#800+[most used byte] | ||
| + | LD DE,#C050 | ||
| + | LD (HL),byte1:INC HL ;plot line 1 | ||
| + | LD (HL),byte2:INC HL | ||
| + | LD (HL),C | ||
| + | LD A,H:ADD B:LD H,A | ||
| + | JR NC,line2 | ||
| + | ADD HL,DE | ||
| + | .line2 | ||
| + | LD (HL),byte6:DEC HL ;plot line 2 | ||
| + | LD (HL),C :DEC HL | ||
| + | LD (HL),byte4 | ||
| + | LD A,H:ADD B:LD H,A | ||
| + | JR NC,line3 | ||
| + | ADD HL,DE | ||
| + | .line3 | ||
| + | LD A,(HL):AND #55:OR byte7:LD (HL),A:INC HL ;plot line 3 (contains transparent areas) | ||
| + | LD (HL),byte8:INC HL | ||
| + | LD A,(HL):AND #AA:OR byte9:LD (HL),A | ||
| + | RET | ||
| + | </pre> | ||
| + | |||
| + | In mode 0 you will need two routines for every sprite, but I think there is no faster way to plot sprites on the CPC. | ||
Revision as of 04:57, 7 May 2007
If you have enough memory, the fastest way to plot sprites is to use the "direct addressing" methode: Here is a small example:
LD HL,screen address LD BC,#800+[most used byte] LD DE,#C050 LD (HL),byte1:INC HL ;plot line 1 LD (HL),byte2:INC HL LD (HL),C LD A,H:ADD B:LD H,A JR NC,line2 ADD HL,DE .line2 LD (HL),byte6:DEC HL ;plot line 2 LD (HL),C :DEC HL LD (HL),byte4 LD A,H:ADD B:LD H,A JR NC,line3 ADD HL,DE .line3 LD A,(HL):AND #55:OR byte7:LD (HL),A:INC HL ;plot line 3 (contains transparent areas) LD (HL),byte8:INC HL LD A,(HL):AND #AA:OR byte9:LD (HL),A RET
In mode 0 you will need two routines for every sprite, but I think there is no faster way to plot sprites on the CPC.
