Difference between revisions of "Amstrad FDD part"

Revision as of 07:56, 12 February 2014

Amstrad used different floppy disk drives during the CPC range live time. These drives where either build-in as in CPC6128 and CPC464 or within the DDI-1/FD-1 external drive extension.

They all shared the following characteristics :

Requires 5V and 12V power supply, except EME-157 which is 5V only.
use CF2 Compact Floppy Disc 3" discs
Single sided
40 tracks
180kB per side (40 tracks/9 512byte sector per track)

Floppy disk models and evolution

EME-150 A

Manufactured by matsushita, this is the original drive used in CPC664 and early DDI1 / CPC6128. Used from 1984 to early 1985.

The chassis is made of one brass aluminium piece on which the disk axis, drive motor, head motor, track 0 detector and head assembly are precisely mounted.
This base is mounted on a folded sheet chassis that support the disk insertion mechanism and a PCB holding the LED for index and write protection sensing as well as connection to track 0 detector.
The insertion mechanism is working by translation of the floppy on the drive mechanism.
Main PCB (30001) can be fully removed to access drive belt.

EME-155

Evolution of the EME-150 A, used during 1985.

Head and floppy motor reference changed and swapped they position. Now the head motor is on the right, the drive one on the left.
Due to the motor swap, the top PCB only support the index and write protection detection led.
Main PCB (30002) can be fully removed to access drive belt.
The optical write protection sensor use a new reference.

EME-156

New design, used from 1986 to 1988

Uses EME-155 head and drive motors.
Full brass aluminium chassis.
New head.
Main PCB (Z70312) cannot be fully removed without de-soldering some wires or un-mounting index sensor and track 0 sensor. Track 0 sensor has to be calibrated when mounted.
Insertion mechanism simplification. The floppy now rotate around the insertion slot toward the floppy drive mechanism. The external visual impact is a slimmer insertion slot.
Index detection led uses a small PCB mounted on the loading mechanism.
The write protection sensing is done using a switch / pin assembly.

EME-156 V

Cost optimised version of the EME-156, used from mid 1988

Brass aluminium chassis has been trimmed of unnecessary bits.
Floppy drive mechanism pulley is changed for a lighter one with a increased diameter. The floppy motor position is slightly moved inward to compensate for the new pulley diameter and keep identical belt.
New head motor with a smaller diameter screw.
Main PCB (Z80264) is 50% smaller than previous version. It cannot be fully removed without de-soldering some wires or un-mounting index sensor and track 0 sensor. Track 0 sensor has to be calibrated when mounted.
The write protection sensing is done using a switch / pin assembly.

EME-157

5 volt only version of EME-156 V. Used in the 6128 plus.

Head and drive motors changed for 5V version.
Main PCB (Z80425) slightly smaller than EME-156 V one. It cannot be fully removed without de-soldering some wires or un-mounting index sensor and track 0 sensor. Track 0 sensor has to be calibrated when mounted.
White face to match Plus range coulor.
Minor modification of the brass chassis near the drive motor
The write protection sensing is done using a switch / pin assembly.