Difference between revisions of "Connector:Analogue joystick (CPC Plus only)"
From CPCWiki - THE Amstrad CPC encyclopedia!
| Line 22: | Line 22: | ||
* Two analogue joysticks could be connected by using an Y-cable. The Fire signals are the same as for the normal (digital) joystick port. Joystick 1 buttons should be connected to Pin 2,4,6, and joystick 2 buttons to Pin 10,12,14. Like the digital [[Joystick Y-cables]] the analog Y-cable should have '''diodes''' in the button lines. | * Two analogue joysticks could be connected by using an Y-cable. The Fire signals are the same as for the normal (digital) joystick port. Joystick 1 buttons should be connected to Pin 2,4,6, and joystick 2 buttons to Pin 10,12,14. Like the digital [[Joystick Y-cables]] the analog Y-cable should have '''diodes''' in the button lines. | ||
* The A/D inputs have an input range of 0V (data = 00) to 2.5V (data = 3Fh), and an input impedance of 180k to Vcc. | * The A/D inputs have an input range of 0V (data = 00) to 2.5V (data = 3Fh), and an input impedance of 180k to Vcc. | ||
| − | * Not sure if the POTs on the CPCs analog X/Y inputs are to be wired to 5V or GND? And, how they are wired on PCs accordingly? | + | * Not sure if the POTs on the CPCs analog X/Y inputs are to be wired to 5V or GND (or to both)? And, how they are wired on PCs accordingly? |
Revision as of 11:44, 25 January 2010
Analogue Joystick Port (15 Pin SUB-D, female) (CPC Plus only)
The Analogue CPC+ Joystick port is somewhat similar to standard PC Joystick ports - with two important differences:
- 5V and GND are exchanged with each other, and,
- on CPC+ the buttons must be connected to a "select" line (instead of to GND).
Pin CPC+ PC 1 Ground +5V 2 /Fire 1 Player 1 Fire 1 3 X1 Player 1 X (lt/rt) 4 /Joystick 1 GND 5 +5V GND 6 Y1 Player 1 Y (up/dn) 7 /Fire 2 Player 1 Fire 2 8 Ground +5V (Soundblaster: GND) 9 Ground +5V 10 /Fire 1 Player 2 Fire 1 11 X2 Player 2 X (lt/rt) 12 /Joystick 2 GND (Soundblaster: Midi TxD) 13 Y2 Player 2 Y (up/dn) 14 /Fire 2 Player 2 Fire 2 15 Ground +5V (Soundblaster: Midi RxD)
- Two analogue joysticks could be connected by using an Y-cable. The Fire signals are the same as for the normal (digital) joystick port. Joystick 1 buttons should be connected to Pin 2,4,6, and joystick 2 buttons to Pin 10,12,14. Like the digital Joystick Y-cables the analog Y-cable should have diodes in the button lines.
- The A/D inputs have an input range of 0V (data = 00) to 2.5V (data = 3Fh), and an input impedance of 180k to Vcc.
- Not sure if the POTs on the CPCs analog X/Y inputs are to be wired to 5V or GND (or to both)? And, how they are wired on PCs accordingly?
