Changes
/* I/O Ports */
* The eight [[Amstrad Serial Interface]] ports are pre-defined as shown above in the AMSDOS ROM. However, neither the CPC 664/6128/Plus nor DDI-1 do actually contain the corresponding RS232 hardware.
* Bit14 of the PAL selection address must be at 1 on CPCs equipped with CRTCs 0/1/2. It can be at 0 or 1 on CRTCs 3/4. For compatibility reasons, it is strongly advised to always set bit14 to 1 to select PAL.
* As components use partial address decoding, it is therefore possible to send the same value to different components '''simultaneously''' by carefully using custom I/O ports.
== Memory Mapped I/O Ports ==
