View source for Schneiderware EPROM Burner

The [[Schneiderware EPROM Burner|Schneiderware Eprommer]] is a EPROM Burner, it supports 24pin and 28pin chips (max 32K bytes), published by german magazine [[CPC Schneider International]] as part of their [[Schneiderware]] DIY series. The plain PCB, or the fully assembled board were also available via mail-order.

The [[ECB Bus]] connector of the board is intended to be plugged into the [[Schneiderware Basisplatine]], but it could be also wired directly to the CPCs Expansion Port. The required EPROM programming voltages are generated by a 5V to 25V converter (and, where needed, lowered to 21V or 12.5V), so one doesn't need an external power supply. The programmed EPROMs can be used (among others) with the [[Schneiderware Pseudo ROM|Schneiderware ROM/EPROM board]].

== I/O Ports ==

{|{{Prettytable|width: 700px; font-size: 2em;}}
|Address (default) || Address (alternate) || Usage
|-
|FAF0h || N/A || Schneiderware Eprom Burner 8255 PPI #1 Port A (Data, 8bit)
|-
|FAF1h || N/A || Schneiderware Eprom Burner 8255 PPI #1 Port B (Address LSBs, 8bit)
|-
|FAF2h || N/A || Schneiderware Eprom Burner 8255 PPI #1 Port C (Address MSBs, 7bit; bit7=unused)
|-
|FAF3h || N/A || Schneiderware Eprom Burner 8255 PPI #1 Control
|-
|FAF4h || N/A || Schneiderware Eprom Burner 8255 PPI #2 Port A (bit0-7=unused)
|-
|FAF5h || N/A || Schneiderware Eprom Burner 8255 PPI #2 Port B (bit0-5=unused, bit6=Red LED, bit7=Green LED)
|-
|FAF6h || N/A || Schneiderware Eprom Burner 8255 PPI #2 Port C (programming signals, 8bit)
|-
|FAF7h || N/A || Schneiderware Eprom Burner 8255 PPI #2 Control
|-
|}

== Pictures ==

<gallery>
File:Schneiderware EPROM Burner Schematic.png|Eprom Burner Schematic
</gallery>

== Scanned Article ==

* [[Media:Schneiderware 9 - Eprommer.pdf|Schneiderware 9 - Eprommer.pdf]] - EPROM Burner - '''6/1987 page 122-131'''