Please note, for the CPC6128 you use 16-bit addressing mode, and these modifications are unnecessary.
=== uIDE-8 "red" boards ===
The uIDE-8 red boards are a previous version of the blue boards and have some minor problems which can be corrected easily.
* The CF_PWR connector has no +5v, due to a pair of missing vias. To fix, insert a link wire as shown in the picture in green. However, you may not need this as certain devices like DOMs can take power from pin 20 of the IDE connector.
* The through holes for the transistor Q1 (shown with a yellow dot) are tight. You may need to drill them out and this will remove the via, so apply solder on both sides of the PCB around Q1's legs. Alternatively, you can surface mount the transistor by bending its legs into feet and standing it on the pads, then carefully solder them. A bit fiddly, but will work.
* The I/O address jumpers are upside down compared to the blue boards. Set the address with reference to the 1 and 0 as printed on the red PCB, not as photoed on this page (the address is the same).
{| class="wikitable"
|-
|[[File:Uide-8 red.JPG|thumbnail|left]]
|}
=== PCW Expansion port adapter video circuit fix ===