Changes

Fischertechnik Trainingsrobot

1,657 bytes removed, 12:52, 7 April 2010
Note: Fischertechnik additionally made the '''Fischertechnik Computing Experimental''' robot kit for the CPC.
This trainingsrobot was also produced for other 8bit computers of the era.([[Commodore 64]]/[[VIC20]] and the [[BBC micro]]) . The only difference was the interface. The interface for the CPC (as well as newer RS232/USB versions) consists of:* 8 single bit inputs ports (eg. for sensing when a robot-arm reached its end-position)* 4 "bidirectional" ports (for motor control) (here "bidirectional" rather means "three-state-output" aka "forward/stop/backward")* 2 analog inputs (eg. for temperature sensor)
== Technical ==
Fischertechnik has built several interfaces:* Interface for Commodore 24pin User Port (used on C64/VIC20)* Interface for one-directional 25pin printer port (used on PCs) (this might have been also used by CPC...? if so, with 34pin/36pin connector, of course)* Interface for RS232 port (used on PCs) (9600 baud, 8bit, no parity, 1 stopbit)* Interface for USB port (used on PCs) === Parallel Printer Port Interface === Connects to the [[Image:Fischertechnik Interface Adapter IBM Amiga Atari 25pol.jpg|right|thumb|25pin PC Adapter]] Designed (see there for one-directional printer ports: Data is read/sent via Pin11/Pin4 (which data is to be transferred is selected via the other DATA lines) (details on how the data is transferred exactly are unknown?). Printer Pin Interface Signal Comment Pin2 (Data Bit0) Load-out ;motor control output Pin3 (Data Bit1) Load-in ;digital sensor 8bit input Pin4 (Data Bit2) Data-out ;data from computer Pin5 (Data Bit3) Clock ;data clock Pin6 (Data Bit4) Trigger-x ;analog sensor X input Pin7 (Data Bit5) Trigger-y ;analog sensor Y input Pin11 (Busy) Data-in ;data to computerThe parallel port interface connects via a 20pin cable, to a printer port adapter (existing adapters are 25pin for PC/Amiga/Atari, 34pin for CPC, or 36pin for german CPC6128).
== Reviews ==
6,388
edits