Changes

Expansion Converter

139 bytes added, 15:43, 10 February 2010
When all wires have been soldered, place the other end of the ribbon cable into the Centronics connector with wire one on the right (looking at the rear of the connector). Ensure the wires are aligned properly before pushing the connector closed. It will be impossible to fully close the connector with your hand, I recommend using a vice to completely close the connector.
Ensure that there are no short-circuits between any of the tracks or connecting wires before connecting the adapter to your CPC !!!
== Dimensions ==
[[Image:Edge_Connector.jpg|600px|centre]]
 
Bryce
[[Category:Hardware]] [[Category:Peripherals]] [[Category:DIY]]
1,179
edits