== Sawtooth and/or Noise==
* Theoretically, the device can output only <either> sawtooth <or> noise?
* But, some block diagrams indicate that it can output both, added together?
* Is there fade-out/fade-in switching from noise to sawtooth, or vice-versa?
== Sample Rate (and related values)==
* is sample rate (the actual sample output speed) 8000Hz or 8096Hz?
* if it is 8000Hz, then exact sample rate would be 3.84MHz/3/160?
* are the P and PI values in table correct (in case 8000 and 8096 are mixed)?
== Filters==
* is EXP formula using "-1*pi" (mess emulator) or "-2*pi" (datasheet)?
== Continue Mode==
* is repeated frame using FD=unchanged or FD=0 (=faster reactions)?
* is repeated frame using PI=unchanged (=can "run out of control")?
== Slow-Stop Mode==
* can one "resurrect" by sending data when already in "stopping" phase?
* does the hardware discard <incomplete> frames on slowstop?
* are FD and PI kept unchanged?
== Random Generator (Noise)==
* works how exactly?
== Interpolations==
* does it take the whole FD period (8..64ms) to reach new target value?
* - AMPL is interpolated on the translated values (eg 0.707)?
* - FM/BW are interpolated on the COS/EXP values?
== Status Register==
* REQ=0 occurs for 3us after 1st..3rd Frame byte (correct)?
* REQ=0 occurs for up to 8..64ms after 4th Frame byte (really/always)?
* is it IMPOSSIBLE to send new data during ACTIVE output (datasheet says so)?
== DAC==
* is there saturation occuring in case samples exceed 8bit range, and when?
== Clock Source==
* can be external crystal, or external TTL, or what... an external <loop>?
== Specifications==* does this doc exist in internet: "MEA8000 voice synthesizer: principles and interfacing, Philips Technical Publication 101" (Philips/Elcoma 1983)?