2,220 bytes added,
12:08, 4 January 2010 MC6850 Asynchronous Communications Interface Adapter (ACIA) (24pin)
== Usage in CPC ==
Used by [[||CPCI_RS232_Interface|CPCI]] (DIY german magazine CPC Schneider International):
F8DCh CPCI Serial Interface MC6850 Control/Status Register (R/W)
F8DDh CPCI Serial Interface MC6850 Data Register (R/W)
Input CLK is 19.2kHz or 38.4kHz (manually selectable via switch)
Status.Bit2 is always 0 in this circuit
IRQ pin is not connected (can be read only by software, in Status.Bit7)
Used by [[KDS_Electronics_Serial_Interface]]:
FBECh KDS RS232 6850 (reversed-bit-order) Control (W)
FBEDh KDS RS232 6850 (reversed-bit-order) TX Data (W)
FBEEh KDS RS232 6850 (reversed-bit-order) Status (R)
FBEFh KDS RS232 6850 (reversed-bit-order) RX Data (R)
Caution: KDS has wired the 6850 chip's data bus incorrectly: D7 is D0,
D6 is D1, etc. (so the bit order must be reversed by software).
Input CLK is 2MHz with variable 16bit divider (programmable 8253 chip)
Used by [[AMSSIO]] (DIY by Martin Zacho):
Port addresses and other details on AMSSIO are unknown
== Registers ==
MC6850 Control Register (W)
0-1 Baudrate (0=CLK/64, 1=CLK/16, 2=CLK/1, 3=RESET)
2-4 Mode (0..7 = 7e2,7o2,7e1,7o1,8n2,8n1,8e1,8o1) (data/stop bits, parity)
5-6 Transmit Interrupt/RTS/Break control (0..3)
0 = Output /RTS=low, and disable Tx Interrupt
1 = Output /RTS=low, and enable Tx Interrupt
2 = Output /RTS=high, and disable Tx Interrupt
3 = Output /RTS=low, and disable Tx Interrupt, and send a Break
7 Receive Interrupt (1=Enable on buffer full/buffer overrun)
MC6850 Status Register (R)
0 Receive Data (0=No data, 1=Data can be read)
1 Transmit Data (0=Busy, 1=Ready/Empty, Data can be written)
2 /DCD level
3 /CTS level
4 Receive Framing Error (1=Error)
5 Receive Overrun Error (1=Error)
6 Receive Parity Error (1=Error)
7 Interrupt Flag (see Control Bits 5-7) (IRQ pin is not connected)
MC6850 Data Register (R/W)
Data can be read when Status.Bit0=1, and written when Status.Bit1=1.
0-7 Data
Rx has a 1-stage fifo, plus 1 shift register (2 stages in total)
Tx has a 1-stage fifo, plus 1 shift register (2 stages in total)