Type "|B" to change to drive B in basic (where ø is the rsx char). A simple CAT will show if the disc/drive works.
=== Other Errors at this point ===
- Bad Command? Floppy drive detected by cpc but is not powered. Recheck your powersupply is connected and working. - You turn on the cpc and both drives act-as-one .. and the floppy light is constantly on? Most likely you didnt short pin 33 & amp; 34 .. is the paperclip/wire loose? .. or did you accidentally short pin 1 & amp; 2 instead? Try moving the paperclip to the other end of the connector. - Read error on drive? Disc hasnt been formatted yet? Use software like Discology to quickly format drive B .. or to quicky copy a disc from A to B .. or make a test floppy on pc (see transfer bit later). - Disc is write protected error? Make sure the write tab on the disc is down (move tab down on right side of disc).
== Two heads (OPTIONAL) ==