Changes

Snapshot

No change in size, 8 September
/* I/O breakpoints */
Where type is not 0, the address mask and address are not stored but can be found in Winape's debugger and they may have a built in condition where specific data or i/o configuration is required.
* 2. This byte represents access type and if there is count and condition data stored. Where type is 0, the access bits are set by the user, otherwise they areset defined by the type and can be seen in the winape debugger.
bit 7,6 = access where bit 7 = write and bit 6 = read. This allows read only, write only and read/write to be specified.
2,562
edits