Schneiderware Basisplatine

The Schneiderware Basisplatine (backplane) is some kind of a ECB Bus motherboard for the Schneiderware DIY series, which was published by german magazine CPC Schneider International. The board has five 64-pin ECB sockets (for use with the DIY boards of the series), a 50-pin connector (for the CPC expansion port), and 7 soldering points (for an optional power supply, like the Schneiderware Power Supply).

The plain PCB, or the fully assembled board were available via mail-order. Unlike as for the other DIY projects of the Schneiderware series, the PCB layout has not been printed (in paper-form) in the magazine (though the magazine offered to send them to interested persons). Another solution would have been to buy a standard ECB backplane (like this), and to build an adaptor for the CPC expansion port by hand.

• 

  Motherboard Pin-Outs

• 

  Basisplatine (component side)

• 

  Basisplatine (solder side)

• 

  Reichelt Euro-Bus-Karte (alternate solution)

• Schneiderware 2 - Backplane and Centronics.pdf - Basisplatine and Printer Port - 7/1986 page 60-67, plus complaints from 10/1986 page 10, port B redefined on 12/1986 page 124 and 3/1987 page 8-9, final notes from 11/1987 page 98

• ECB Bus