SYMBiFACE II:IDE registers
From CPCWiki - THE Amstrad CPC encyclopedia!
The Symbiface 2 operates the ATA/IDE device in 16-bit data transfer mode. 16-bits of data is buffered at a time within the Symbiface 2 and read/written via the Data port I/O address 8 bits at a time. The device was designed when devices didn't support ATA CFA command set and 8-bit PIO data transfer so this is why it buffers 16-bit of data. (16-bits is the "native" data transfer of an ATA device).
The I/O ports operate in a "pass-through" like mode where the registers directly reflect those of the connected ATA device.
The X-Mass is a more modern ATA/IDE device which is compatible with the Symbiface 2 IDE registers and uses the same I/O ports.
This is the documentation about the IDE registers of the SYMBiFACE II expansion card.
| Port | Read | Write |
| #FD06 | Alternate Status | Digital Output |
| #FD07 | Drive Address | (Not Used) |
| #FD08 | Data Register | Data Register |
| #FD09 | Error Register | Features Register/(Write Precomp Reg.) |
| #FD0A | Sector Count (0=256) | Sector Count (0=256) |
| #FD0B | Sector Number for CHS or LBA bits 0-7 | Sector Number for CHS or LBA bits 0-7 |
| #FD0C | Cylinder Low for CHS or LBA bits 8-15 | Cylinder Low for CHS or LBA bits 8-15 |
| #FD0D | Cylinder High for CHS or LBA bits 16-23 | Cylinder High for CHS or LBA bits 16-23 |
| #FD0E | Device/Head Register (Bit 6=0 CHS, Bit 6=0 LBA) (Bit 4 = 0 Master, Bit 4 = 1 Slave) (Bits 3..0 Head for CHS or LBA bits 24-27) | (Bit 6=0 CHS, Bit 6=0 LBA) (Bit 4 = 0 Master, Bit 4 = 1 Slave) Device/Head Register (Bits 3..0 Head for CHS or LBA bits 24-27) |
| #FD0F | Status Register | Command Register |
