Difference between revisions of "MIDI"
From CPCWiki - THE Amstrad CPC encyclopedia!
(Created page with 'Musical Instrument Digital Interface (MIDI) == Software Protocol == Basicall transmits commands like key on, key off, plus pitch/volume parameters. Write more... == Hardware …') |
(→Hardware Protocol) |
||
Line 12: | Line 12: | ||
* The signals are transmitted as TTL levels (0V and 5V) (unlike +/-12V on RS232) with 5V reference voltage (unlike 0V on RS232) | * The signals are transmitted as TTL levels (0V and 5V) (unlike +/-12V on RS232) with 5V reference voltage (unlike 0V on RS232) | ||
* The receiver should pass the TTL signal through an Opto-Isolator | * The receiver should pass the TTL signal through an Opto-Isolator | ||
− | * The 31250 Hz | + | * The 31250 Hz baudrate isn't a standard RS232 rate |
* MIDI is one-directional (MIDI OUT implements only TX, no RX, and MIDI IN implements only RX, no TX) | * MIDI is one-directional (MIDI OUT implements only TX, no RX, and MIDI IN implements only RX, no TX) | ||
− | * There are no control signals like CTS/RTS/DTR used | + | * There are no control signals like CTS/RTS/DSR/DTR used |
== Schematic == | == Schematic == |
Revision as of 18:19, 8 August 2010
Musical Instrument Digital Interface (MIDI)
Contents
Software Protocol
Basicall transmits commands like key on, key off, plus pitch/volume parameters.
Write more...
Hardware Protocol
The data is transferred at 31250 bits per second, using 8-N-1 format (one start bit, eight data bits, no parity bit, and one stop bit). So far, the MIDI protocol is much similar to RS232, and many MIDI interfaces do actually use standard "RS232" UART chips. Differences to RS232 are:
- The signals are transmitted as TTL levels (0V and 5V) (unlike +/-12V on RS232) with 5V reference voltage (unlike 0V on RS232)
- The receiver should pass the TTL signal through an Opto-Isolator
- The 31250 Hz baudrate isn't a standard RS232 rate
- MIDI is one-directional (MIDI OUT implements only TX, no RX, and MIDI IN implements only RX, no TX)
- There are no control signals like CTS/RTS/DSR/DTR used
Schematic
MIDI Interfaces for the CPC
- DHCP MIDI Interface (DHCP Electronics)
- EMR MIDI Interface (MIDI) (ElectroMusic Research)
- Music Machine (Sampling/Playback/MIDI) (RAM Electronics)
- Silicon Systems MIDI Interface
Weblinks
- http://www.midi.org/ - MIDI Manufacturers Association (MMA)
- http://en.wikipedia.org/wiki/MIDI_1.0 - wikipedia on MIDI 1.0
- http://en.wikipedia.org/wiki/Musical_Instrument_Digital_Interface - wikipedia on MIDI in general