Difference between revisions of "MEA8000 Unknown Details"
From CPCWiki - THE Amstrad CPC encyclopedia!
| Line 1: | Line 1: | ||
| + | [[Category:Electronic Component]][[Category:Music and sound]] | ||
| + | |||
There are still a LOT of unknown details for the [[MEA8000]]. Since the chip is software programmable, it should be very easy to reverse-engineer that details - unfortunately, nobody did so, yet. | There are still a LOT of unknown details for the [[MEA8000]]. Since the chip is software programmable, it should be very easy to reverse-engineer that details - unfortunately, nobody did so, yet. | ||
Revision as of 16:06, 17 December 2010
There are still a LOT of unknown details for the MEA8000. Since the chip is software programmable, it should be very easy to reverse-engineer that details - unfortunately, nobody did so, yet.
Contents
Sawtooth and/or Noise
- Theoretically, the device can output only <either> sawtooth <or> noise?
- But, some block diagrams indicate that it can output both, added together?
- Is there fade-out/fade-in switching from noise to sawtooth, or vice-versa?
- is sample rate (the actual sample output speed) 8000Hz or 8096Hz?
- if it is 8000Hz, then exact sample rate would be 3.84MHz/3/160?
- does P register overflow after 8000 or 8096 steps?
- are fm_cos and bw_exp values using divider 8000 or 8096?
- are the P and PI values in table correct (in case 8000 and 8096 are mixed)?
Filters
- is EXP formula using "-1*pi" (mess emulator) or "-2*pi" (datasheet)?
Continue Mode
- is repeated frame using FD=unchanged or FD=0 (=faster reactions)?
- is repeated frame using PI=unchanged (=can "run out of control")?
Slow-Stop Mode
- can one "resurrect" by sending data when already in "stopping" phase?
- does the hardware discard <incomplete> frames on slowstop?
- works exactly as when resending the current frame but with AMPL=0?
- are FD and PI kept unchanged?
Random Generator (Noise)
- works how exactly?
Interpolations
- does it take the whole FD period (8..64ms) to reach new target value?
- - AMPL is interpolated on the translated values (eg 0.707)?
- - FM/BW are interpolated on the COS/EXP values?
Status Register
- REQ=0 occurs for 3us after 1st..3rd Frame byte (correct)?
- REQ=0 occurs for up to 8..64ms after 4th Frame byte (really/always)?
- REQ=0 occurs for up to 8ms after Initial Pitch (really/why)?
- is it REQUIRED to send new data during ACTIVE output (to prevent slowstop)?
- is it IMPOSSIBLE to send new data during ACTIVE output (datasheet says so)?
DAC
- is there saturation occuring in case samples exceed 8bit range, and when?
Clock Source
- can be external crystal, or external TTL, or what... an external <loop>?
Specifications
- does this doc exist in internet: "MEA8000 voice synthesizer: principles and interfacing, Philips Technical Publication 101" (Philips/Elcoma 1983)?
