Difference between revisions of "SP0256 Pin-Outs"
From CPCWiki - THE Amstrad CPC encyclopedia!
| (2 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
* [[SP0256 Allophones]] | * [[SP0256 Allophones]] | ||
* [[SP0256 Pin-Outs]] | * [[SP0256 Pin-Outs]] | ||
| + | * [[SP0256 on Printer Port (DIY)]] | ||
== SP0256 - Speech chip == | == SP0256 - Speech chip == | ||
| Line 36: | Line 37: | ||
28 OSC2 | 28 OSC2 | ||
| − | The oscillator should be 3.12MHz | + | * The oscillator should be usually 3.12MHz (in practice, it's often different). |
| − | Allows to output sounds up to 5kHz (ie. the output is updated at 10kHz rate). | + | * Allows to output sounds up to 5kHz (ie. the output is updated at 10kHz rate). |
| − | The SP0256 is reportedly expandable to "491 K of ROM" (probably bullshit). | + | * The SP0256 is reportedly expandable to "491 K of ROM" (probably bullshit). |
| − | The SP0256B is reportedly expandable to "480 K of ROM" (probably K=Kbits). | + | * The SP0256B is reportedly expandable to "480 K of ROM" (probably K=Kbits). |
| − | The TEST pin of the SP0256 chip can be used (among others) to dump its internal ROM. Note: Details on TEST are found in the "SP0256B" datasheet - but not in the "SP0256" datasheet - not sure if the pin works identical for both chip types, nor if there's a difference between them at all. | + | * The TEST pin of the SP0256 chip can be used (among others) to dump its internal ROM. Note: Details on TEST are found in the "SP0256B" datasheet - but not in the "SP0256" datasheet - not sure if the pin works identical for both chip types, nor if there's a difference between them at all. |
| + | |||
| + | == External ROMs == | ||
| + | |||
| + | For curiostiy, below are the pin-outs for external speech ROMs (though none of the known speech interfaces for the CPC uses them). | ||
== SPR16 (16kbit) and SPR32 (32kbit) - External Serial-bus Speech ROM == | == SPR16 (16kbit) and SPR32 (32kbit) - External Serial-bus Speech ROM == | ||
| Line 75: | Line 80: | ||
23 C1 | 23 C1 | ||
24 C2 | 24 C2 | ||
| + | |||
| + | [[Category:Music and sound]] | ||
Latest revision as of 16:50, 19 December 2010
- SP0256
- SP0256 Voice Generator
- SP0256 Instruction Set
- SP0256 Allophones
- SP0256 Pin-Outs
- SP0256 on Printer Port (DIY)
Contents
SP0256 - Speech chip
1 GND 2 /RESET 3 ROM DISABLE 4 C1 5 C2 6 C3 7 VCC1 8 SBY 9 /LRQ 10 A8 11 A7 12 SER OUT 13 A6 14 A5 15 A4 16 A3 17 A2 18 A1 19 SE 20 /ALD 21 SER IN 22 TEST 23 VCC2 24 PWM OUT 25 /SBY RESET 26 ROM CLK 27 OSC1 28 OSC2
- The oscillator should be usually 3.12MHz (in practice, it's often different).
- Allows to output sounds up to 5kHz (ie. the output is updated at 10kHz rate).
- The SP0256 is reportedly expandable to "491 K of ROM" (probably bullshit).
- The SP0256B is reportedly expandable to "480 K of ROM" (probably K=Kbits).
- The TEST pin of the SP0256 chip can be used (among others) to dump its internal ROM. Note: Details on TEST are found in the "SP0256B" datasheet - but not in the "SP0256" datasheet - not sure if the pin works identical for both chip types, nor if there's a difference between them at all.
External ROMs
For curiostiy, below are the pin-outs for external speech ROMs (though none of the known speech interfaces for the CPC uses them).
SPR16 (16kbit) and SPR32 (32kbit) - External Serial-bus Speech ROM
1 GND 2 C3 3 NC 4 ROM CLK 5..6 NC 7 CS1 8 /CS2 9 /ROM ENABLE 10 SERIAL OUT 11 VCC 12..13 NC 14 SERIAL IN 15 C1 16 C2
SPR128 (128kbit) - External Serial-bus Speech ROM
1 GND 2 C3 3 NC 4 ROM CLK 5..10 NC 11 CS1 12 /CS2 13 /ROM ENABLE 14 SERIAL OUT 15 VCC 16..21 NC 22 SERIAL IN 23 C1 24 C2
