Difference between revisions of "Fischertechnik Interface"
Cpcmaniaco (Talk | contribs) |
Cpcmaniaco (Talk | contribs) (→Tape) |
||
| Line 16: | Line 16: | ||
== Tape == | == Tape == | ||
| + | |||
| + | <gallery caption="Fischertechnik Interface"> | ||
| + | |||
| + | Image:Fischertechnik Tape - side B.jpg|side B | ||
| + | Image:Fischertechnik Tape - side A.jpg|side A | ||
| + | |||
| + | </gallery> | ||
== Download == | == Download == | ||
Revision as of 10:26, 3 September 2010
The Fischertechnik Interface is used for :
- the Fischertechnik Trainingsrobot
- the Fischertechnik Computing Experimental kit
- the Fischertechnik Plotter/Scanner.
Contents
Inputs/Outputs
The interface for the CPC (as well as newer RS232/USB versions) consists of:
- 8 single bit inputs ports (eg. for sensing when a robot-arm reached its end-position)
- 4 "bidirectional" ports (for motor control) (here "bidirectional" rather means "three-state-output" aka "forward/stop/backward")
- 2 analog inputs (eg. for temperature sensor)
Covertape
Tape
- Fischertechnik Interface
side B
side A
Download
Interface Versions
Fischertechnik has built several interfaces:
- Interface for Parallel Ports (used on C64/VIC20/CPC/PC/Atari/Amiga)
- Interface for RS232 Ports (used on PCs) (9600 baud, 8bit, no parity, 1 stopbit)
- Interface for USB Ports (used on PCs)
Parallel Printer Port Interface
Designed for one-directional Printer Ports: Data is read/sent via Pin11/Pin4 (which data is to be transferred is selected via the other DATA lines) (details on how the data is transferred exactly are unknown?).
Printer Pin Interface Signal Comment Pin2 (Data Bit0) Load-out ;motor control output Pin3 (Data Bit1) Load-in ;digital sensor 8bit input Pin4 (Data Bit2) Data-out ;data from computer Pin5 (Data Bit3) Clock ;data clock Pin6 (Data Bit4) Trigger-x ;analog sensor X input Pin7 (Data Bit5) Trigger-y ;analog sensor Y input Pin11 (Busy) Data/Count-in ;data to computer (some variants seem to have separate pins: Busy=Data-in and Ack=Count-in) Pin.. (GND) Ground ;ground
The parallel fischertechnik interface has a 20pin (or 10pin) cable (the 10pin cable was used in early commodore versions, the 20pin variant was invented to simplify printer-port connections, which have GND on each 2nd wire). The various supported computers have different pin-outs: 24pin Edge (C64/VIC20), 25pin DSUB (PC/Amiga/Atari), 34pin Edge (CPC464/CPC664), or 36pin Centronics (german CPC6128). To solve that, some cables have a N-pin connector on a 20-pin cable. Others have a 20-pin connector, with additional 20-pin to N-pin adaptor.
Pictures
Schneider Interface (20pin cable with 34pin connector)
Commodore Interface (10pin cable with 24pin connector)
PC/Amiga/Atari (20pin-to-25pin adapter)
Timing diagram from sascha-bader.de
Weblinks
- http://sascha-bader.de/html/ftpc2c64.html - Fischertechnik DIY Adapters
