Changes

Jump to: navigation, search

V9990

656 bytes added, 12:33, 29 December 2018
/* Technical */
* Powergraph generates a maskable interrupt on CPC.
 
=== Reset ===
 
The following has been tested using the "software reset" which is triggered through the control port.
 
* After rest all registers are reset to 0.
 
* The elected register (port 4) is set to 0 and port read and write increment is not inhibited.
 
* If reset is held using the "software reset" then reading or writing to the VRAM data port will cause the CPC to hang. I believe the V9990 is continuously asserting /WAIT but I can't confirm through code.
 
* Reset will stop any commands in progress and will clear pending interrupts.
 
* If reset is held: 3,4,7,8,9,10,11,12,13,14 and 15 reads databus, port 1 reads 0, port 5 and 6 read status,
== Command Engine ==
2,562
edits