Changes
/* NLQ401 */
|DS2-2||Line Feed Spacing||colspan=2|Force ESC "2" to act as 1/8 or 1/6 inch<br>Note: Service manual claims DS2-2 selects UK/French characters, that is wrong, not supported by firmware||ESC "2" cannot be reassigned by software (but software can use ESC "0", ESC "1", ESC "3" to control linefeeds)
|-
|DS2-3||International characters||colspan=2|Select US-ASCII or German characters||Can be changed by ESC "6" / ESC "7" (which are NLQ401-specific codes, non-Epson compatible)
|-
|DS2-4||Draft/NLQ Mode||colspan=2|Select Draft or NLQ mode<br>Note: Service manual claims it slects Slashed/Unslashed Zero, that is wrong.||Can be also changed by ESC "x" (Epson-compatible code), or by ESC "I" (equivalent NLQ401-specific, non-Epson compatible code)
|DS2-5||1 inch skip perforation||Invalid/Disable (default)||Valid/Enable||Can be also changed via ESC "N"/ESC "O"
|-
|DS2-6||Not used||colspan=2|Unused according to service manual, that is wrong. It seems to control something like wrapping to next line when the line is full (or so)||?
|-
|DS2-7||CR Function||CR+LF||CR only (default)||Affects chr(0Dh) / Also affected by /AUTOLF signal
