Changes
[[Image:SDTut13.JPG|600px|centre]]
Well done, you did your first soldering for today and a good job if your LCD is still working correctly. So on to the next steps.....
Change the red and the orange wire of the Disc Drive power connector inside your CPC6128 and remove the 12V spiral cable. You won't ever need it again. The CPC doesn't use the standard pinout, 12V and 5v are not connected in normal way. So we change it back to the standard pinout. 5Volt at the correct side please. I used a micro screwdriver to hold up the little white pin and pull out the cable. Then simply change its position. It clicks smoothly inside....done.....
[[Image:SDTut14.JPG|600px|centre]]
[[Category:Hardware]] [[Category:Peripherals]] [[Category:DIY]][[Category:DATA Storage]]
