Changes

Jump to: navigation, search

CIO Registers (Detailed)

7,751 bytes added, 18:29, 29 January 2010
* [[CIO Registers (Summary)]]
* [[CIO Registers (Detailed)]]
 
== CIO Registers ==
 
* Control Register 00h - Master Interrupt Control Register (R/W)
7 MIE Master Interrupt Enable
6 DLC Disable Lower Chain
5 NV No Vector
4 PAVIS Port A Vector Includes Status
3 PBVIS Port B Vector Includes Status
2 CTVIS Counter/Timers Vector Includes Status
1 Right Justifies Addresses
0=Shift Left (A0 from AD1)
1=Right Justify (A0 from AD0)
0 Reset (Caution: If set, requires a 3rd write to resurrect)
 
* Control Register 01h - Master Configuration Control Register (R/W)
7 PBE Port B Enable
6 CT1E Counter/Timer 1 Enable
5 CT2E Counter/Timer 2 Enable
4 PCE/CT3E Port C and Counter/Timer 3 Enable
3 PLC Port A-and-B Link Control (0=operate independently, 1=linked)
2 PAE Port A Enable
0-1 LC Counter/Timer Link Controls (see below)
 
* Counter/Timer Link Controls values are:
0=Counter/Timers are Independent
1=Counter/Timer 1's /OUTPUT does Gate Counter/Timer 2
2=Counter/Timer 1's /OUTPUT does Trigger Counter/Timer 2
3=Counter/Timer 1's /OUTPUT is Counter/Timer 2's Count Input
 
* Control Register 20h - Port A Mode Specification Register (R/W)
* Control Register 28h - Port B Mode Specification Register (R/W)
7-6 PTS Port Type Select (0=Bit Port, 1=Input, 2=Output, 3=Bidirectional)
5 ITB Interrupt on Two Bytes
4 SB Single Buffered Mode
3 IMO Interrupt on Match Only
2-1 PMS Pattern Mode Specification (0=None, 1=AND, 2=OR, 3=OR-Priority)
0 LTM Latch on Pattern Match (in Bit Mode), or
0 DTE Deskew Timer Enable (in Handshake Modes)
 
* Control Register 21h - Port A Handshake Specification Register (R/W)
* Control Register 29h - Port B Handshake Specification Register (R/W)
7-6 HTS Handshake Type (0=Interlocked, 1=Strobed, 2=Pulsed, 3=Three-Wire)
5-3 RWS Request/Wait (0=Request/WAIT Disabled, 1=Output /WAIT, 3=Input /WAIT,
4=Special Req, 5=Input Request, 7=Output Request)
2-0 Deskew Time (MSBs of Deskew Timer Time Constant, LSB is forced 1)
 
* Control Register 08h - Port A Command and Status Register (Parts R/W)
* Control Register 09h - Port B Command and Status Register (Parts R/W)
* Control Register 0Ah - Counter/Timer 1 Command and Status (Parts R/W)
* Control Register 0Bh - Counter/Timer 2 Command and Status (Parts R/W)
* Control Register 0Ch - Counter/Timer 3 Command and Status (Parts R/W)
7-5 Set/Clear Command (Write Only) (see command list)
7 IUS Interrupt Under Service (Read Only)
6 IE Interrupt Enable (Read Only)
5 IP Interrupt Pending (Read Only)
4 ERR Interrupt Error (Read Only)
 
* For Port A/B Registers:
3 ORE Output Register Empty (Read Only)
2 IRF Input Register Full (Read Only)
1 PMF Pattern Match Flag (Read Only)
0 IOE Interrupt on Error
 
* For Counter/Timer Registers:
3 RCC Read Counter Control (Read/Set Only - cleared by reading CCR LSB)
2 GCB Gate Command Bit
1 TCB Trigger Command Bit (Write Only) (Read returns 0)
0 CIP Counter in Progress (Read Only)
 
* Set/Clear Command List:
0=Null Code, 1=Clear IP & IUS
2=Set IUS, 3=Clear IUS
4=Set IP, 5=Clear IP
6=Set IE, 7=Clear IE
 
* Control Register 22h - Data Path Polarity Register Port A (R/W)
* Control Register 2Ah - Data Path Polarity Register Port B (R/W)
* Control Register 05h - Data Path Polarity Register Port C (4 LSBs only) (R/W)
7-0 DPP Data Path Polarity bits (0=Non-inverting, 1=Inverting)
 
* Control Register 23h - Data Direction Register Port A (R/W)
* Control Register 2Bh - Data Direction Register Port B (R/W)
* Control Register 06h - Data Direction Register Port C (4 LSBs only) (R/W)
7-0 DD Data Direction bits (0=Output Bit, 1=Input Bit)
 
* Control Register 24h - Special I/O Control Register Port A (R/W)
* Control Register 2Ch - Special I/O Control Register Port B (R/W)
* Control Register 07h - Special I/O Control Register Port C (4 LSBs only)(R/W)
7-0 SIO Special Input/Output bits (0=Normal Input or Output,
1=Output with open drain, or Input with 1's catcher)
 
* Control Register 0Dh - Port Data Register Port A (R/W) (directly addressable)
* Control Register 0Eh - Port Data Register Port B (R/W) (directly addressable)
7-0 Data Bits7-0 (usually 0=Low, 1=High, unless Polarity is inverted)
 
* Control Register 0Fh - Port Data Register Port C (R/W) (directly addressable)
7-4 Lock Bits3-0 (0=Writing Enabled, 1=Writing Inhibited)(Read returns 1)
3-0 Data Bits3-0 (usually 0=Low, 1=High, unless Polarity is inverted)
 
* Control Register 25h - Port A Pattern Polarity (PP) Register (R/W)
* Control Register 26h - Port A Pattern Transition (PT) Register (R/W)
* Control Register 27h - Port A Pattern Mask (PM) Register (R/W)
* Control Register 2Dh - Port B Pattern Polarity (PP) Register (R/W)
* Control Register 2Eh - Port B Pattern Transition (PT) Register (R/W)
* Control Register 2Fh - Port B Pattern Mask (PM) Register (R/W)
7-0 Pattern Bits (PP/PT/PM for Pattern Polarity/Transition/Mask accordingly)
Possible combinations of the PP/PT/PM Bits are:
PM PT PP Pattern Specification
0 0 x Bit Masked Off
0 1 x Any Transition
1 0 0 Zero
1 0 1 One
1 1 0 One-to-Zero Transition (falling edge)
1 1 1 Zero-to-One Transition (raising edge)
 
* Control Register 1Ch - Counter/Timer 1 Mode Specification (R/W)
* Control Register 1Dh - Counter/Timer 2 Mode Specification (R/W)
* Control Register 1Eh - Counter/Timer 3 Mode Specification (R/W)
7 C/SC Continuous/Single Cycle (0=Singe Cycle, 1=Continuous)
6 EOE External Output Enable
5 ECE External Count Enable
4 ETE External Trigger Enable
3 EGE External Gate Enable
2 REB Retrigger Enable
1-0 DCS Output Duty Cycle Select (0=Pulse,1=OneShot,2=SquareWave,3=Reserved)
 
* Control Register 10h - Counter/Timer 1 Current Count Register MSB (R)
* Control Register 11h - Counter/Timer 1 Current Count Register LSB (R)
* Control Register 12h - Counter/Timer 2 Current Count Register MSB (R)
* Control Register 13h - Counter/Timer 2 Current Count Register LSB (R)
* Control Register 14h - Counter/Timer 3 Current Count Register MSB (R)
* Control Register 15h - Counter/Timer 3 Current Count Register LSB (R)
7-0 CCR Current Count Register (Read Only) (8bits of 16bit total)
 
* Control Register 16h - Counter/Timer 1 Time Constant Register MSB (R/W)
* Control Register 17h - Counter/Timer 1 Time Constant Register LSB (R/W)
* Control Register 18h - Counter/Timer 2 Time Constant Register MSB (R/W)
* Control Register 19h - Counter/Timer 2 Time Constant Register LSB (R/W)
* Control Register 1Ah - Counter/Timer 3 Time Constant Register MSB (R/W)
* Control Register 1Bh - Counter/Timer 3 Time Constant Register LSB (R/W)
7-0 TCR Time Constant Register (aka Reload value) (8bits of 16bit total)
 
* '''Control Register 02h - Interrupt Vector Register Port A (R/W)'''
* '''Control Register 03h - Interrupt Vector Register Port B (R/W)'''
* '''Control Register 04h - Interrupt Vector Register Counter/Timers (R/W)'''
7-0 Interrupt Vector (Bit3-1 may be automatically modified, see below)
Port A/B: In Priority Encoded Vector Mode:
3-1 Number of highest Priority Bit with a match
 
* '''Port A/B: In all other Modes:'''
3-1 Bit3-1=All zero if Error, or otherwise Bit3=ORE, Bit2=IRF, Bit1=PMF
Counter/Timer:
3 Not auto-modified
2-1 Counter/Timer Number (0=C/T3, 1=C/T2, 2=C/T1, 3=Error)
 
* '''Control Register 1Fh - Current Vector Register (R)'''
7-0 Interrupt Vector Based on highest priority unmasked IP (IP=int pending)
If no interrupt pending then all 1's are output (ie. register is FFh)
6,388
edits